Configuration D-Link Web Smart Switch User Manual
3
3
7
7
Priority: The 802.1p priority levels of the traffic in the Auto Surveillance VLAN. The possible values are
Highest, High, Medium and Low.
Tagged Uplink/Downlink Port: Specifies the ports to be tagged uplink port or downlink port for the Auto
Surveillance VLAN.
Click Apply to implement the changes.
User-defined MAC Settings:
Component Type: Auto Surveillance VLAN will automatically detect D-Link Surveillance Devices by default.
There are another five surveillance components that could be configured to be auto-detected by the Auto
Surveillance VLAN. These five components are Video Management Server (VMS), VMS client/Remote
viewer, Video Encoder, Network Storage and Other IP Surveillance Devices.
Description: Here to input the description for the component type.
MAC/OUI: You can manually create an MAC or OUI address for the surveillance component. The maximum
number of user defined MAC address is 5. System will auto generate an ACL profile (Profile ID: 53) for all the
Auto Surveillance VLAN rules.
Click Add to create a new surveillance component and Refresh to refresh the Auto Surveillance VLAN
summary table.
L2 Functions > Jumbo Frame
D-Link Gigabit Web Smart Switches support jumbo frames (frames larger than the Ethernet frame size of
1536 bytes) of up to 13,004 bytes (tagged). Default is Disabled. Click Enabled, and then Apply to turn on
the jumbo frame support.
Figure 4.36 – L2 Functions > Jumbo Frame
L2 Functions > Port Mirroring
Port Mirroring is a method of monitoring network traffic that forwards a copy of each incoming and/or
outgoing packet from one port of the Switch to another port, where the packet can be studied. This enables
network managers to better monitor network performances. The function is Disabled by default. Click
Enabled to enable the function.
Figure 4.37 – L2 Functions > Port Mirroring
Selection options for the Source Ports are as follows:
To Next Page
Loading...
