D-Link DGS-1210-08P - Security > Smart Binding > White List; Security > Smart Binding > Black List

Configuration D-Link Web Smart Switch User Manual
7
7
4
4
Figure 4.88 – Security > Smart Binding > Smart Binding
Manual Binding:
IPv4 Address: Specifies the IPv4 address to bind to the MAC address set below.
IPv6 Address: Specifies the IPv6 address to bind to the MAC address set below.
MAC Address: Specifies the MAC address to bind to the IP address set above.
Port: Specify the Switch ports for which to configure this IP-MAC binding entry (IP Address + MAC Address).
Click Add to add a new entry.
Auto Scan: This setting will list connected devices that can easily be selected to bind.
IP Address From/To: Specifies the range of IP address that will be scanned.
Click Scan and the search results will be listed in the table.
Binding: Tick this option to bind the IP address of the entry to the MAC address.
Click Apply to accept the changes made.
Click Select All to select all the entries found.
Click Clear All to unselect all the entries found.
Security > Smart Binding > White List
When IP + ARP Inspection Mode is selected, the White List page displays finished IP-MAC-Port Binding
entries from page Smart Binding. Only IP packets or ARP packets carrying matched IP-MAC-Port
information can access to the switch. You can cancel a device’s authorization by deleting it from the table.
Figure 4.89 – Security > Smart Binding > White List
Select the check box of entry then click Delete to remove it.
Click Select All to select all entries of the table or click Clean to select none entries. Please keep at least
one management host in the White List.
Security > Smart Binding > Black List
The Black List page shows unauthorized accesses. When ARP Inspection is selected and a device sends
out an ARP packet containing unmatched IP-MAC-Port information, the device will be forbidden and listed
here.