D-Link DGS-1210-08P - Ping6; Reboot

Command Line Interface D-Link Web Smart Switch User Manual
1
1
0
0
9
9
ping6
Purpose This command is used to test the IPv6 connectivity between the
Switch and other network devices.
Syntax
ping6 <ipv6addr> {times <value 1-255> | size <value 1-6000> |
timeout <sec 1-99>}
Description
The ping6 command checks if another IPv6 address is reachable
on the network. You can ping the IPv6
address through the
managed VLAN (VLAN 1 by default), as long as there is a physical
path between the Switch and the target IPv6
equipment. By
default, the Switch sends five pings to the target IPv6 address.
Parameters
<ipv6addr> - Enter the IPv6 address of the host.
times <value 1-255> - Enter the ping times value here. This value
must be between 1 and 255.
size <value 1-6000> - Enter the ping size value here. This value
must be between 1 and 6000.
timeout <sec 1-99> -Enter the ping timeout value here. This value
must be between 1 and 99 seconds.
Restrictions None.
Example usage:
To ping the IP address 3FFE:2::D04D:7878:66D:E5BC:
DGS-1210-24:admin#ping6 3FFE:2::D04D:7878:66D:E5BC
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000, time<10 ms
Ping Statistics for 3FFE:2::D04D:7878:66D:E5BC
Packets: Sent =5, Received =5, Lost =0
DGS-1210-24:admin#
reboot
Purpose This command is used to reboot the Switch. If the Switch is a
member of a stack, it may be rebooted individually, without
affecting the other members of the stack.
Syntax
reboot
Description
The reboot command reboots the Switch. All network connections
are terminated and the boot code executes.
Parameters None.
Restrictions None.
Example usage:
To reboot the Switch: