D-Link DGS-1210-08P - SNMP > SNMP > SNMP Community; SNMP > SNMP > SNMP Host

Configuration D-Link Web Smart Switch User Manual
9
9
6
6
Figure 4.114 – SNMP > SNMP > SNMP View
View Name: Name of the view, up to 32 characters.
Subtree OID: The Object Identifier (OID) Subtree for the view. The OID identifies an object tree (MIB tree)
that will be included or excluded from access by an SNMP manager.
OID Mask: The mask of the Subtree OID. 1 means this object number is concerned, 0 means do not
concerned. For example 1.3.6.1.2.1.1 with mask 1.1.1.1.1.1.0 means 1.3.6.1.2.1.X.
View Type: Specify the configured OID is Included or Excluded that a SNMP manager can access.
Click Add to create a new SNMP view name. Click Delete to remove the corresponding entry.
SNMP > SNMP > SNMP Community
This window is used to maintain the SNMP community string of the SNMP managers using the same
community string are permitted to gain access to the Switch's SNMP agent.
Figure 4.115 –SNMP > SNMP > SNMP Community
Community Name: Type an alphanumeric string of up to 32 characters that is used to identify members of
an SNMP community. This string is used like a password to give remote SNMP managers access to MIB
objects in the Switch’s SNMP agent.
User Name (View Policy): Specifies that the SNMP community string will be created with privileges that can
either be ReadOnly or ReadWrite. Alternatively, an existed user name can be selected that will be used
together with the community string. The privileges will depend on the SNMP user that was created.
Click Add to create a new SNMP community. Click Delete to remove the corresponding entry.
SNMP > SNMP > SNMP Host
This SNMP Host window is used to configure the SNMP trap recipients.