D-Link DGS-1210-08P - L2 Functions > LLDP > LLDP Port Settings; L2 Functions > LLDP > 802.1 Extension TLV

Configuration D-Link Web Smart Switch User Manual
5
5
2
2
From Port/ To Port: A consecutive group of ports may be configured starting with the selected port.
Extended PSE TLV: Select to enable or disable the extended PSE TLV option.
Click Apply to implement the changes made. Click Refresh to refresh the table information.
L2 Functions > LLDP > LLDP Port Settings
The Basic LLDP Port Settings page displays LLDP port information and contains parameters for configuring
LLDP port settings.
Figure 4.57 – L2 Functions > LLDP > LLDP Port Settings
From Port/ To Port: A consecutive group of ports may be configured starting with the selected port.
Notification State: Specifies whether notification is sent when an LLDP topology change occurs on the port.
The default is Disabled.
Admin Status: Specifies the LLDP transmission mode on the port. The possible field values are:
TX_Only – Enables transmitting LLDP packets only.
RX_Only – Enables receiving LLDP packets only.
TX_and_RX – Enables transmitting and receiving LLDP packets. This is the default.
Disabled – Disables LLDP on the port.
Port Description: Specifies whether the Port Description TLV is enabled on the port.
System Name: Specifies whether the System Name TLV is enabled on the port.
System Description: Specifies whether the System Description TLV is enabled on the port.
System Capabilities: Specifies whether the System Capabilities TLV is enabled on the port.
Click Apply to implement the changes made. Click Refresh to refresh the table information.
L2 Functions > LLDP > 802.1 Extension TLV
This 802.1 Extension TLV page is used to configure the LLDP Port settings.