D-Link DGS-1210-08P - Show Switch; Config Account Admin Password

Command Line Interface D-Link Web Smart Switch User Manual
1
1
1
1
1
1
DGS-1210-24:admin#show ipif
IP Setting Mode : Static
IP Address : 10.90.90.90
Subnet Mask : 255.0.0.0
Default Gateway : 10.90.90.1
DHCPv6 Client State : Disabled
IPv6 Link-Local Address : FE80::280:C2FF:FE12:2400/128
DGS-1210-24:admin#
show switch
Purpose This command is used to display information about the Switch.
Syntax
show switch
Description
The show switch command displays information about the
Switch.
Parameters None.
Restrictions None.
Example usage:
To display the Switch’s information:
DGS-1210-24:admin#show switch
System Name :
System Location :
System Contact :
System up time : 0 days, 4 hrs, 0 min, 51 secs
System Time : 4/1/2013 15:05:49
System hardware version :
System firmware version : 4.10.007
System boot version : 0.00.005
System serial number :
MAC Address : 00-80-C2-12-24-00
DGS-1210-24:admin#
config account admin password
Purpose This command is used to configure the administrator user account
password used on the Switch.
Syntax
config account admin password <password>
Description
The config account admin password command configures the
administrator user account password used on the Switch.
Parameters
<password> − Enter the new password for the administrator
account.
Restrictions None.