IDENTIFYING EXTERNAL COMPONENTS
This chapter describes the front panel, rear panel, and LED
indicators of the Switch.
Front Panel
The figure below shows the front panels of the Switch.
Figure 4. Front panel of 16-port Gigabit Ethernet Switch.
LED Indicator:
Comprehensive LED indicators display the status of the Switch
and the network (see the LED Indicators chapter below).
Gigabit Ethernet Ports (Port 1~16):
The Switch has sixteen Gigabit twisted pair ports, which support auto negotiable
10/100/1000Mbps and auto MDI/MDIX crossover detection function. This function
provides true “plug and play” capability; you just need to plug-in the network
cable to the hub directly regardless of if the end node is NIC (Network Interface
Card) or switch and hub.
These ports can operate in half-duplex mode for 10/100Mbps
and full-duplex mode for 10/100/1000Mbps.
Mini GBIC Ports
The Switch is equipped with two mini-GBIC ports, which support
optional 1000BASE-SX/LX mini-GBIC modules.
Note: When the port is set to “Forced Mode”, the Auto MDI/MDIX will be
disabled.
To Next Page
Loading...
Need help?
General