32
Abnormal* Receive Error: A trap when there is a receive data
error in the copper port.
Abnormal* Transmit Error: A trap when there is a transmit
data error in the copper port.
Abnormal*: 50 error packet count within 10 seconds.
Set Password
Password is the invaluable tool for the manager to secure the Web
Management Switch. This function is used to change the
password.
If you forget the password, press the “Reset” button in the rear
panel of the Switch. Current switch settings, such as VLAN, Port
Setting… etc. will be lost and the Switch will be restored to the
factory default settings.
Figure 27. Set Password
Backup Setting
The backup tools help you to backup the current switch settings.
To backup the settings, click the “Backup” button to save the
setting.
To restore a current setting file to the device, you must specify the
backup file and click the “Restore” button to implement the
settings of the recorded file.
To Next Page
Loading...
Need help?
General