19
IP Address: Shows the current IP address of the device.
MAC Address: Shows the device MAC Address.
Protocol version: Shows the version of the Utility protocol.
Product Name: Shows the device product name.
System Name: Shows the appointed device system name.
Location: Shows where the device is located.
Trap IP: Shows the IP where the Trap will be sent.
Subnet Mask: Shows the Subnet Mask set of the device.
Gateway: Shows the Gateway set of the device.
View Trap: The Trap function can receive the events that occur
from the Web Management Switch in the Monitor List.
There is a light indicator behind the “View Trap” button. When
the indicator lights green, it means that there is no trap transmitted.
When it lights red, it means that a new trap has been transmitted,
reminding the user to view the trap. (Figure 8)
Figure 8.
When the “View Trap” button is clicked, a Trap Information
window will appear, displaying the trap information including, the
Symbol, Time, Device IP, and the Event occured. (Figure 9)
The symbol “
” represents a new trap signal; this symbol will
disappear after you review and click on the event record.
To Next Page
Loading...
