D-Link DGS-3120-24TC - NLB FDB Settings

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
131
Figure 4–96 LLDP Remote Port Information – Show Normal window
Click the <<Back button to return to the previous page.
NLB FDB Settings
The Switch supports Network Load Balancing (NLB). This is a MAC forwarding control for supporting the Microsoft
server load balancing application where multiple servers can share the same IP address and MAC address. The
requests from clients will be forwarded to all servers, but will only be processed by one of them. In multicast mode,
the client uses a multicast MAC address as the destination MAC to reach the server. Regardless of the mode, the
destination MAC is the shared MAC. The server uses its own MAC address (rather than the shared MAC) as the
source MAC address of the reply packet. The NLB multicast FDB entry will be mutually exclusive with the L2
multicast entry.
To view this window, click L2 Features > NLB FDB Settings, as shown below.
Figure 4–97 NLB Multicast FDB Table window
The following fields can be set:
Parameter Description
VLAN Name
Click the radio button and enter the VLAN of the NLB multicast FDB entry to be
created.
VID (1-4094)
Click the radio button and enter the VLAN by the VLAN ID.
MAC Address
Enter the MAC address of the NLB multicast FDB entry to be created.
Unit
Select the unit you wish to configure.
Click the Apply button to accept the changes made.
Click the Clear All button to remove all the entered information in the fields.
Click the Edit button to update the information of the corresponding entry.
Click the Delete button to delete the corresponding entry.