D-Link DGS-3120-24TC - VLAN Translation Settings

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
76
Parameter Description
QinQ State
Selecting this option enable the QinQ feature.
Inner TPID
Enter an Inner TPID in SP-VLAN tag here.
Unit
Specifies the unit ID to be configured.
From Port – To
Port
Here the user can select a range of ports to use in the configuration.
Role
Port role in QinQ mode, it can be UNI port or NNI port
Missdrop
This option enables or disables C-VLAN based SP-VLAN assignment miss drop. If
Missdrop is enabled, the packet that does not match any assignment rule in the QinQ
profile will be dropped. If disabled, then the packet will be forwarded and will be assigned
to the PVID of the received port.
Outer TPID
Enter an Outer TPID in SP-VLAN tag here.
Add Inner Tag Specifies that an Inner Tag will be added to the entry. By default the Disabled option is
selected.
Click the Apply button to accept the changes made for each individual section.
VLAN Translation Settings
This page can be used to add translation relationship between C-VLAN and SP-VLAN. On ingress at UNI port, the
C-VLAN tagged packets will be translated to SP-VLAN tagged packets by adding or replacing according the
configured rule. On egress at this port, the SP-VLAN tag will be recovered to C-VLAN tag or be striped. The priority
will be the priority in the SP-VLAN tag if the inner priority flag is disabled for the receipt port.
To view the following window, click L2 Features > QinQ > VLAN Translation Settings, as show below:
Figure 4–27 VLAN Translation Settings Window
The fields that can be configured are described below:
Parameter Description
Unit
Specifies the unit ID used here.
From Port – To
Port
Here the user can select a range of ports to use in the configuration.
CVID
Here the user can enter the C-VLAN ID to match.
Action
The action indicates to add an S-tag before a C-tag or to replace the original C-tag by an
S-tag.
SVID
Here the user can enter the SP-VLAN ID.
Priority
Here the user can select the priority of the s-tag.
Click the Apply button to accept the changes made for each individual section.
Click the Delete All button to remove all the entries listed.