D-Link DGS-3120-24TC - System Log Server Settings

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
15
Time Interval – Users who choose this method can configure a time interval by which the
Switch will save the log files, in the box adjacent to this configuration field. The user may set
a time between 1 and 65535 minutes.
Log Trigger – Users who choose this method will have log files saved to the Switch every
time a log event occurs on the Switch.
Click the Apply button to accept the changes made.
System Log Server Settings
The Switch can send System log messages to up to four designated servers using the System Log Server.
To view the following window, click System Configuration > System Log Configuration > System Log Server
Settings, as show below:
Figure 2–13 System Log Server Settings (SI Mode Only)
Figure 2–14 System Log Server Settings (EI Mode Only)
The fields that can be configured are described below:
Parameter Description
Server ID
Syslog server settings index (1 to 4).
Server IPv4 Address
The IPv4 address of the Syslog server.
Server IPv6 Address
(EI Mode Only)
The IPv6 address of the Syslog server.
UDP Port
Type the UDP port number used for sending Syslog messages. The default is 514.
Severity
Use the drop-down menu to select the higher level of messages that will be sent. All
messages which level is higher than selecting level will be sent. The options are
Emergency, Alert, Critical, Error, Warning, Notice, Informational and Debug.
Facility Use the drop-down menu to select Local 0, Local 1, Local 2, Local 3, Local 4, Local 5,
Local 6, or Local 7.
Status
Choose Enabled or Disabled to activate or deactivate.
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.