D-Link DGS-3120-24TC - Operations, Administration, and Maintenance (OAM); CFM Configuration

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
257
Figure 9–4 DHCP Relay Interface Settings window
The fields that can be configured are described below:
Parameter Description
Interface Name
The IP interface on the Switch that will be connected directly to the Server.
Server IP Address
Enter the IP address of the DHCP server. Up to four server IPs can be configured per
IP Interface.
Click the Apply button to accept the changes made.
DHCP Relay VLAN Settings (SI Mode Only)
This page allows the user to configure an IP address as a destination to forward (relay) DHCP/BOOTP packets. If
there is an IP interface in the VLAN and it has configured a DHCP server at the interface level, then the
configuration at the interface level has higher priority. In this case, the DHCP server configured on the VLAN will
not be used to forward the DHCP packets.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay VLAN Settings as shown
below:
Figure 9–5 DHCP Relay VLAN Settings window
The fields that can be configured are described below:
Parameter Description
VID List
Enter the VLAN ID list used for this configuration here.
Server IP Address
Enter the DHCP/BOOTP server IP address used here.
Click the Add button to add an entry.
Click the Delete button to remove an entry.
DHCP Relay Option 60 Server Settings
On this page the user can configure the DHCP relay option 60 server parameters.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Server
Settings as shown below: