xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
53
SNMPv6 Host Table Settings (EI Mode Only)
Users can set up SNMP trap recipients for IPv6.
To view the following window, click Management > SNMP Settings > SNMPv6 Host Table Settings, as show
below:
3–42 SNMPv6 Host Table Settings
The fields that can be configured are described below:
Parameter Description
Host IPv6 Address
Type the IPv6 address of the remote management station that will serve as the
SNMP host for the Switch.
User-based Security
Model
SNMPv1 – Specifies that SNMP version 1 will be used.
SNMPv2 – Specifies that SNMP version 2 will be used.
SNMPv3 – Specifies that SNMP version 3 will be used.
Security Level NoAuthNoPriv – To specify that the SNMP version 3 will be used, with a NoAuth-
NoPriv security level.
AuthNoPriv – To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
AuthPriv – To specify that the SNMP version 3 will be used, with an Auth-Priv security
Type in the community string or SNMP V3 user name as appropriate.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
RMON Settings
On this page the user can enable or disable remote monitoring (RMON) for the rising and falling alarm trap feature
for the SNMP function on the Switch.
To view the following window, click Management > SNMP Settings > RMON Settings, as show below:
Figure 3–43 RMON Settings window
The fields that can be configured are described below:
Parameter Description
Enable this option to use the RMON Rising Alarm Trap Feature.
To Next Page
Loading...
