D-Link DGS-3120-24TC - Page 213

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
205
Figure 8–14 Authentication RADIUS Server Settings window (SI Mode Only)
Figure 8–15 Authentication RADIUS Server Settings window (EI Mode Only)
The fields that can be configured are described below:
Parameter Description
Index Choose the desired RADIUS server to configure: 1, 2 or 3 and select the IPv4
Address.
Server IP (SI Mode Only)
Set the RADIUS server IP address.
IPv4 Address (EI Mode
Only)
Set the RADIUS server IP address.
IPv6 Address (EI Mode
Only)
Set the RADIUS server IPv6 address.
Authentication Port
Set the RADIUS authentic server(s) UDP port which is used to transmit
RADIUS data between the Switch and the RADIUS server. The default port is
1812.
Accounting Port
Set the RADIUS account server(s) UDP port which is used to transmit RADIUS
accounting statistics between the Switch and the RADIUS server. The default
port is 1813.
Timeout
Set the RADIUS server age-out, in seconds.
Retransmit
Set the RADIUS server retransmit time, in times.
Key
Set the key the same as that of the RADIUS server.