D-Link DGS-3120-24TC - Page 234

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
226
Figure 8–37 Port Security Settings window
The fields that can be configured are described below:
Parameter Description
Port Security
Trap/Log Settings
Use the radio button to enable or disable Port Security Traps and Logs on the Switch.
System Max Address
Enter the system maximum address.
Unit
Select the unit you want to configure.
From Port
The beginning port of a consecutive group of ports to be configured.
To Port
The ending port of a consecutive group of ports to be configured.
Admin State
Use the pull-down menu to enable or disable Port Security (locked MAC address
table for the selected ports).
Lock Address Mode
This pull-down menu allows the option of how the MAC address table locking will be
implemented on the Switch, for the selected group of ports. The options are:
Permanent – The locked addresses will only age out after the Switch has been reset.
DeleteOnTimeout – The locked addresses will age out after the aging timer expires.
DeleteOnReset – The locked addresses will not age out until the Switch has been
reset or rebooted.
Max Learning
Address
Specify the maximum value of port security entries that can be learned on this port.
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to re-configure the specific entry.
Click the View Detail button to display the information of the specific entry.
After clicking the View Detail button, the following page will appear: