EasyManua.ls Logo

D-Link DPN-101G

D-Link DPN-101G
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2D-Link DPN-101G User Manual
Section 1 - Product Overview
Introduction
The D-Link DPN-101G is a mini GPON ONT that uses a GPON link to deliver high-speed broadband. Its plug-and-play capabilities coupled with a
small form factor make it ideal for residential applications. With bridging for Triple-play, users can use data-intensive Internet devices simultaneously
without experiencing network delay. To give users better access to the Internet, the 10/100/1000 Mbps Ethernet is equipped with this GPON
residential gateway. Supporting IEEE 802.3az the DPN-101G delivers energy ecient Ethernet to the home.
Safety Precautions
Take the following instructions to prevent the device from risks and damage caused by re or electric power:
Use the type of power marked by the volume label.
Use the power adapter packed in the device package.
Pay attention to the power load of the outlet or prolonged lines. An overburden power outlet or damaged lines and plugs may cause electric
shock or re accident. Check the power cords regularly. If you nd any damage, replace it at once.
Proper space left for heat dissipation is necessary to avoid damage caused by overheating to the device. The long and thin holes on the device
are designed for heat dissipation to ensure that the device works normally. Do not cover these heat dissipation holes.
Do not put this device close to a place where a heat source exists or high temperature occurs. Avoid the device from direct sunshine.
Do not put this device close to a place where it is overdamp or watery. Do not spill any uid on this device.
Do not connect this device to any PCs or electronic products, unless our customer engineer or your broadband provider instructs you to do this,
because any wrong connection may cause power or re risk.
Do not place this device on an unstable surface or support.
System Requirements
Recommended system requirements are as follows:
A 10/100/1000 base-T Ethernet card is installed on your PC
A Router or Switch. (connected to several PCs through one of Ethernet interfaces on the device)
Operating system: Windows 98 SE, Windows 2000, Windows ME, Windows XP, Windows Vista, Windows 7, Windows 8, Windows 10
Internet Explorer V5.0 or higher, Netscape V4.0 or higher, or Firefox 1.5 or higher

Other manuals for D-Link DPN-101G

Related product manuals