D-Link DSR-1000N - DMZ LAN DHCP Reserved IPs

Unified Services Router CLI Reference Guide
63
8
dead_interval
The number of seconds that a
device’s hello packets must not have
been seen before its neighbors declare
the OSPF router dow n.This value must
be the same for all routers attached to a
common network.The defaul t value is 40
seconds.
Unsigned integer
9
cost
The cost of sending a packet on an
OSPFv3 interface
Unsigned integer
8.40 net port management configure
<ltportName>
S.No
Command Name
Description
Type and Description
1
<ltportName>
port management configuration mode.
Port name
2
save
Save port management configuration
changes.
3
exit
Save port management configuration
changes and exit current mode.
4
cancel
Roll back port management configuration
changes.
5
enable
Enable/Disable the port status
Boolean choice
6
auto_negotiation_enable
Select this to let the gateway and
network to determine the optimal port
settings.
Boolean choice
7
duplex_mode
Choose betw een Half Duplex and Full
Duplex based on the port support. The
default is Full Duplex for all ports.
select the duplex mode
8
speed
One of three port speeds can be
selected: 10 Mbps, 100 Mbps and 1000
Mbps (i.e. 1 Gbps). The default setting is
1000 Mbps for all ports
select the speed
8.41 net wan pppoe configure
S.No
Command Name
Description
Type and Description
1
save
Save pppoe configuration changes.
2
cancel
Roll back pppoe configuration changes.
3
exit
Save pppoe configuration changes and
current mode.
4
UserName
Set user name
String
5
Passw ord
Set Passw ord
String
6
AuthMode
Select Authentication Type
PPPOE Authentication Types.
7
Service
Set service name
String
8
CompressionEnable
Enable/Disable Compression Negotiation
Boolean choice
9
ConnectionMode
Set Connection Mode type
Boolean choice
10
IdleTimeOutValue
Set Idle TimeOut Value (in min)
PPPOE idle timeout Type.
11
GetIpFromIspEnable
Enable/Disable GetIpFromIsp
Boolean choice