D-Link DSR-1000N - Dynamic DNS Settings

Unified Services Router CLI Reference Guide
64
12
StaticIp
Set static IP Address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
13
NetMask
Set subnet mask
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
14
GetDnsFromIspEnable
Enable/Disable GetDnsFromIsp
Boolean choice
15
PrimaryDns
Set Primary DNS
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
16
SecondaryDns
Set Secondary DNS
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
8.42 net routing protocol_binding add
S.No
Command Name
Description
Type and Description
1
save
Save Protocol-Binding rules configuration
changes.
2
exit
Save Protocol Binding rules configuration
changes and exit current mode.
3
cancel
Roll back configuration changes.
4
Service
Available Service
service type
5
Local_Gatew ay
local gateway type
WAN interface type
6
Source_Netw ork
source network type
firew all rule address type
7
Destination_Netw ork
destination netw ork type
firew all rule address type
8
source_address_start
starting IP of the Source Netw ork
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
9
source_address_end
ending IP of the Source user
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
10
destination_address_start
start IP of the Destination user
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
11
destination_address_end
ending IP of the Destiation user
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
8.43 net routing protocol_binding edit
<ltrow_id>
S.No
Command Name
Description
Type and Description
1
<ltrow_id>
protocol_binding rules configuration
mode.
Unsigned integer
2
save
Save Protocol-Binding rules configuration