D-Link DSR-1000N - System Snmp Sys Configure; System Snmp Access Add; System Snmp Access Edit <Ltrowid

Unified Services Router CLI Reference Guide
96
3
exit
save SNMP v3 Users configuration changes and exit
current mode.
4
cancel
Roll back SNMP v3 Users configuration changes.
5
security_level
authentication and privacy settings .
snmp security level type for
snmpv3users list
6
authentication_algo
choose betw een MD5 or SHA authentication
snmpv3uers list authentication
algorithm type
7
privacy_algorithm
DES-56 privacy is available for the authentication
negotiation
snmpv3uers list privacy algorithm
type
8
authentication_password
shared authentication password with the SNMPv3
user.
String
9
privacy_password
shared privacy password with the SNMPv3 user
String
10.10 system snmp sys configure
S.No
Command Name
Description
Type and Description
1
save
Save SNMP system configuration changes.
2
cancel
Roll back snmp configuration changes.
3
exit
Save SNMP system configuration changes and exit current mode.
4
sys-contact
Set system contact information.
String
5
sys-location
Set system location information.
String
6
sys-name
Set system name information.
String
10.11 system snmp access add
S.No
Command
Name
Description
Type and Description
1
save
Save SNMP access control configuration changes.
2
exit
Save SNMP access configuration changes and exit current mode.
3
cancel
Roll back snmp configuration changes.
4
agent
The IP address of the SNMP agent.
IP address AAA.BBB.CCC.DDD
w here each part is in the range
0-255
5
subnet_mask
The netw ork mask used to determine the list of allow ed SNMP
managers. To allow any IP on the netw ork to manager the device
enter 255.255.255.0. For a specific host, enter 255.255.255.255. To
allow global access, enter 0.0.0.0.
IP address AAA.BBB.CCC.DDD
w here each part is in the range
0-255
6
accessType
SNMP trap port the trap messages w ill be sent to.
String
7
community
The community string to w hich the agent belongs. Most agents are
configured to listen for traps in the Public community
String
10.12 system snmp access edit <ltrowid>
S.No
Command
Name
Description
Type and Description
1
<ltrowid>
snmp configuration mode
Unsigned integer
2
save
Save SNMP access control configuration changes.
3
exit
Save SNMP access configuration changes and exit current mode.