D-Link DSR-250 - Net Ipv6_Tunnel Isatap Add;Edit; Net Ipv6_Tunnel Isatap Delete <Row_Id; Net Ipv6_Tunnel Six_To_Four Configure

Unified Services Router CLI Reference Guide
23
Sl No
Command Name
Description
Type and Description
Password.
5
wild_flag_enable
Enable / Disable using wild cards
Boolean (Y/N)
Wildcard flag
6
time_update_enable
Set Timeperiod as 30 days
Boolean (Y/N)
Update for every 30 days or not
7
cancel
Roll back DDNS configuration changes
8
exit
Save DDNS configuration changes and
exit current mode
9
save
Save DDNS configuration changes
8.5 net ipv6_tunnel isatap add/edit
Sl No
Command Name
Description
Type and Description
1
end_point_type
This is the endpoint address for the
tunnel that starts with this router. The
endpoint can be the LAN interface
(assuming the LAN is an IPv4 network),
or a specific LAN IPv4 address.
Local end point address type
(LAN/Other_IP),
2
ipv4_address
The local end point address if not the
LAN IPv4 address
IP Address
The local end point address
3
subnet_prefix
This is the 64-bit subnet prefix that is
assigned to the logical
String, subnet prefix
4
cancel
Roll back isatap tunnel configuration
changes.
5
exit
Save isatap tunnel configuration
changes and exit current mode.
6
save
Save isatap tunnel configuration
changes.
8.6 net ipv6_tunnel isatap delete <row_id>
Sl No
Command Name
Description
Type and Description
1
row_id
Row Id of the tunnel to be deleted
Unsigned integer
Row id number
8.7 net ipv6_tunnel six_to_four configure
Sl No
Command Name
Description
Type and Description
1
automatic_tunneling_enable
Enable/disable automatic tunneling
which will allow traffic from an IPv6 LAN
to be tunneled through a IPv4 WAN to
reach an IPv6 network
Boolean (Y/N)
Enable/ Disable automatic
tunneling