D-Link DSR-250 - Chapter 11. Configuration Commands under Branch DOT11; Dot11 Access Point Configure <Ap_Name; Dot11 Access Point Delete <Ap_Name

Unified Services Router CLI Reference Guide
64
Chapter 11. Configuration commands
under branch DOT11
11.1 dot11 access point configure <ap_name>
Sl No
Command Name
Description
Type and Description
1
ap_name
Unique name of the access point
String,
Access point name
2
acl_policy_status
Policy, Set the default ACL policy for
AP.
policy Name of the policy.
(Open/Allow/Deny)
3
enable_active_time
Indicates if the AP is enabled/disabled
by a daily timer.
indicates if the AP is
enabled/disabled by a daily timer.
(Y/N)
4
max_associated_clients
Set maximum number of client that can
associate with AP.
Maximum number of clients.
5
start_time hour
the hour of the day when the AP is
activated (and available for use if
enabled).
Hours 1 to 12
6
start_time meridian
the meridian of the day when the AP is
activated (and available for use if
enabled).
Meridiem am/pm
7
start_time minute
the minute of the day when the AP is
activated (and available for use if
enabled).
Minute in the format MM (00-59)
8
stop_time hour
the hour of the day when the AP is
deactivated.
Hours 1 to 12
9
stop_time meridian
the meridian of the day when the AP is
deactivated
Meridiem am/pm
10
stop_time minute
the minute of the day when the AP is
deactivated
Minute in the format MM (00-59)
11
cancel
Roll back AP configuration changes
12
exit
Save AP configuration changes and
exit current mode.
13
save
Save AP configuration changes
11.2 dot11 access point delete <ap_name>
Sl No
Command Name
Description
Type and Description
1
ap_name
Unique name of the access point
String,
Access point name