D-Link DSR-250 - Dot11 Radio Configure <Radio_Num

Unified Services Router CLI Reference Guide
67
Sl No
Command Name
Description
Type and Description
6
preamble_mode <preamble>
Set the 802.11b preamble type to be
prepended to every frame
802.11b preamble type to be
prepended to every frame
(Long/Short)
7
rts_cts_protection <enabled>
Enable/disable RTS/CTS handshake
before packet transmission.
Enable/Disable RTS/CTS
handshake. (Y/N)
8
rts_threshold <threshold>
Set the Request to Send (RTS)
threshold.
Request to Send (RTS) threshold.
9
short_retry_limit <limit>
Set the retry limit for frame
retransmission on transmission failure.
Frame re-transmission limit.
10
cancel
Roll back radio configuration changes
11
exit
Save radio configuration changes and
exit current mode.
12
save
Save radio configuration changes
11.9 dot11 radio configure <radio_num>
Sl No
Command Name
Description
Type and Description
1
radio_num
Radio to configure
Unsigned integer,
Radio number
2
channel <channel>
Set the channel used by radio.
Unsigned integer,
Channel number (or Auto to let
system select).
3
channel_spacing <value>
Select either 20 MHz or 40 MHz
channel bonding (spacing).
Select either 20 MHz or 40 MHz
channel bonding (spacing)
(20MHz/20-40MHz/40MHz)
4
country <country>
Set country.
country name
(USA/INDIA/CANADA/HONG_KO
NG/CHINA/AUSTRALIA/SINGAPO
RE/THAILAND/BRUNEI_DARUSS
ALAM/INDONESIA/NEW_
ZEALAND/PHILIPPINES/VIETNA
M)
5
default_transmit_power
<value>
Set default trans power for APs using
this radio.
Transmitted power level (in %)
(100%/75%/50%/25%/0%)
6
operating_frequency <value>
Select either 2.4GHz or 5GHz based
on the radio’s capabilities and your
wireless network requirements.
Select either 2.4GHz or 5GHz
based on the radio’s capabilities
and your wireless network
requirements (2.4GH
z/5GHz)
7
cancel
Roll back radio configuration changes
8
exit
Save radio configuration changes and
exit current mode.
9
save
Save radio configuration changes