D-Link DSR-250 - Security Firewall Ipv4 Delete <Row_Id

Unified Services Router CLI Reference Guide
48
Sl No
Command Name
Description
Type and Description
5
dnat_address <dnatAddr>
Send to Local Server (DNAT
IP),Specifies an IP address and port
number of a machine on the Local
Network which is host
IP address AAA.BBB.CCC.DDD
where each part is in the range 0-
255
6
dnat_port <dnatport>
The port number to use for DNAT,
required if port forwarding is enabled
Port number (0..65535)
7
log <log>
Enable / Disable Logs
Log type,
Never/Always
8
schedule <schedule>
Schedule for which the rule is
applicable
String
Schedule for which the rule is
applicable
9
service_name <service>
Name of the service for which a rule is
to be added
String
Name of the service for which a
rule is to be added
10
snat_address <snatAddr>
IP of the SNAT Address
IP Address
IP of the SNAT Address
11
snat_address_type
<snatType>
Type of the SNAT address
snat type WAN1/Single Address
12
source_address_end
<srcAddrEnd>
End IP of the Source user
IP Address
End IP of the Source user
13
source_address_start
<srcAddrStart>
Start IP of the Source user
Start IP of the Source user
14
source_address_type
<srcType>
Type of the source user
Type of user address,
Any/Single Address/Address
Range
15
internet_destination
<internetDest>
Enter WAN/OTHER. Set it as WAN
port, if more than one is available, that
is the internet destination for traffic
covered by this firewall rule.
internet destination type
(WAN/OTHERS)
16
internet_destination_address
<internetDestAddr>
The WAN IP address that will map to
the incoming server.
IP address AAA.BBB.CCC.DDD
where each part is in the range 0-
255
17
port_forwarding_enable
<dnatenable>
enable/disable port forwarding based
on type of firewall rule configured
Boolean choice (Y/N)
18
rule_type <ruleType>
Type of rule to be configured
firewall rule type (WAN-To-
LAN/Inbound/LAN-To-
WAN/Outbound)
19
cancel
Roll back firewall ipv4 rules
configuration changes
20
exit
Save firewall ipv4 rules configuration
changes and exit current mode.
21
save
Save firewall ipv4 rules configuration
changes.
9.11 security firewall ipv4 delete <row_id>
Sl No
Command Name
Description
Type and Description
1
security firewall ipv4 delete
Row Id Of the rule to be deleted
Integer,