DIR-100 Ethernet Broadband Router
Setup Wizard – Configure PPTP Client Connection
NOTE: The broadband device used for your Cable or ADSL network
connection must support PPTP pass-through so the VPN session can be
established.
The Router supports Point-to-Point Tunneling Protocol (PPTP) for the Internet connection. PPTP is also used
for Virtual Private Networks (VPN). Some ISPs use PPTP to establish a client-to-server connection to their
network, and ultimately to the Internet. If your Internet connection comes through a PPTP client connection
to a server owned by your ISP, the IP settings and user account information must be pre-configured on the
remote server before network access is granted.
To configure the PPTP client connection, enter the IP and account information for the Router. Your ISP will
give this information to you if you are establishing a PPTP connection to the ISP. Click Next to continue.
PPTP Connection Setting Description
My IP Address
Enter the IP address for your DIR-100 based on the
information provided to you by your ISP.
Subnet Mask
Enter the Subnet Mask for your DIR-100 based on the
information provided to you by your ISP.
Gateway IP Address
Enter the Gateway IP address based on the information
provided to you by your ISP.
Server IP Address
Enter the IP address of the ISP server with which your router
will be conveying encrypted information. This field is based on
information provided to you by your ISP.
PPTP Account
Enter the name of the PPTP account as provided to you by
your ISP.
PPTP Password
Enter the PPTP password as provided to you by your ISP.
Retype Password
Retype the password entered in the Password field.
16
To Next Page
Loading...
