D-Link N300 - Page 107

DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Hostname
The name of the device assigned to its IP address in the local subnet.
Figure 90. Configuring the local interface. The IPv4 tab. The Dynamic IP Addresses section.
Parameter Description
Dynamic IP Addresses
Mode of dynamic IP
address assignment
An operating mode of the router's DHCP server.
• Disable: The router's DHCP server is disabled, clients' IP
addresses are assigned manually.
• Server: The router assigns IP addresses to clients
automatically in accordance with the specified parameters.
When this value is selected, the Start IP, End IP, Lease
time fields and the DNS relay switch are displayed on the
tab. Also when this value is selected, the DHCP Options,
Static IP Addresses, and Hosts sections are displayed on
the tab.
• Relay: An external DHCP server is used to assign IP
addresses to clients. When this value is selected, the
External DHCP server IP, Option 82 Circuit ID,
Option 82 Remote ID, and Option 82 Subscriber ID
fields are displayed on the tab. Available if the Router,
WISP Repeater, or Mobile Internet mode was selected
in the Initial Configuration Wizard.
Start IP
The start IP address of the address range used by the DHCP server to
distribute IP addresses to clients.
Page 107 of 238