DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
In the opened window, you can specify the following parameters:
Parameter Description
Enable
Move the switch to the right to enable the route.
Move the switch to the left to disable the route.
Protocol
An IP version.
Interface
From the drop-down list, select an interface (connection) through
which the device will communicate with the remote network. If you
have selected the Auto value, the router itself sets the interface
according to the data on the existing dynamic routes.
Destination network
A remote network which can be accessed with help of this route. You
can specify an IPv4 or IPv6 address.
The format of a host IPv6 address is 2001:db8:1234::1, the
format of a subnet IPv6 address is 2001:db8:1234::/64.
Destination netmask
For IPv4 protocol only.
The remote network mask.
Gateway
An IP address through which the destination network can be accessed.
Metric
A metric for the route. The lower the value, the higher is the route
priority. Optional.
Table
From the drop-down list, select a routing table for the route.
• group_1 table is used to route user traffic.
• main table is used to route management traffic from internal
system services of the router.
After specifying the needed parameters, click the SAVE button.
To edit an existing route, select a relevant line of the table. In the opened window, change the
needed parameters and click the SAVE button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the DELETE button ( ).
Page 186 of 238
To Next Page
Loading...
