D-Link N300 User Manual

DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Basic Settings
On the USB Modem / Basic Settings page, you can view data on the USB modem connected to
the router and enable/disable the function for automatic creation of 3G/LTE WAN connection upon
plugging a USB modem into the router.
Figure 130. The USB Modem / Basic Settings page.
If the Automatic creation of connection switch is moved to the right and the PIN code check
for the SIM card inserted into your USB modem is disabled, then an active WAN connection with
default settings (for LTE modems) or the operator's settings (for GSM modems) will be
automatically created when plugging the USB modem into the router. The connection will be
displayed on the Connections Setup / WAN page.
If you don't want to use this function, move the Automatic creation of connection switch to
the left and click the APPLY button.
When a USB modem is connected to the router, the following data are displayed in the
Information section:
Parameter Description
Vendor
The manufacturer of your USB modem.
Model The alphanumeric code of the model of your USB modem.
Revision
The revision of the firmware of your USB modem.
IMSI The code stored in the SIM card inserted to your USB modem.
IMEI
The code stored in the memory of the USB modem.
Page 162 of 236

D-Link N300 Specifications

General

Wireless Speed	300 Mbps
Frequency Band	2.4 GHz
Wireless Standards	IEEE 802.11n/g/b
Antenna Type	Internal
Ports	1 x 10/100 Mbps Ethernet Port
Security	WPA, WPA2
Product Type	Range Extender