DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Click the APPLY button.
To set a schedule for a virtual server, click the Set schedule button ( ) in the line
corresponding to this server. In the opened window, you can create a new schedule (see the
Schedule section, page 217) or use the existing one. Existing schedules are displayed in the
Interval of execution drop-down list in the simplified mode.
To enable the virtual server at the time specified in the schedule and disable it at the other time,
select the Enable rule value from the Action drop-down list and click the SAVE button.
To disable the virtual server at the time specified in the schedule and enable it at the other time,
select the Disable rule value from the Action drop-down list and click the SAVE button.
To edit the parameters of an existing server, select the relevant line in the table. On the opened page,
change the needed parameters and click the APPLY button.
To change or delete the schedule for a server, click the Edit schedule button ( ) in the line
corresponding to this server. In the opened window, change the parameters and click the SAVE
button or click the DELETE FROM SCHEDULE button.
To remove a server, select the checkbox located to the left of the relevant line of the table and click
the DELETE button ( ). Also you can remove a server on the editing page.
Page 201 of 238
To Next Page
Loading...
