DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Installation and Connection
9. In the opened Wireless Network Connection window, select the wireless network DIR-
620S and click the Connect button.
Figure 21. The list of available networks.
10. In the opened window, enter the network key (see WPS PIN on the barcode label on the
bottom panel of the device) in the Security key field and click the Next button.
11. Allow or forbid your PC to be discoverable by other devices on this network (Yes / No).
Figure 22. PC discovery settings.
12. Wait for about 20-30 seconds. After the connection is established, the network icon will be
displayed as a dot with curved lines indicating the signal level.
!
If you perform initial configuration of the router via Wi-Fi connection, note that
immediately after changing the wireless default settings of the router you will need to
reconfigure the wireless connection using the newly specified settings.
Page 37 of 238
To Next Page
Loading...
