DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
If needed, you can add your own address resource records. To do this, click the ADD button ( )
in the Hosts section (available if the Router, WISP Repeater, or Mobile Internet mode was
selected in the Initial Configuration Wizard).
Figure 94. Configuring the local interface. The IPv4 tab. The window for adding a DNS record.
In the IP address field, specify a host from the internal or external network. You can choose a
device connected to the router's LAN at the moment. To do this, select the relevant IPv4 address
from the drop-down list (the field will be filled in automatically). In the Name field, specify the
domain name to which the specified IPv4 address will correspond. Click the SAVE button.
To edit an existing record, in the Hosts section, select the relevant line in the table. In the opened
window, change the needed parameters and click the SAVE button.
To remove a record, in the Hosts section, select the checkbox located to the left of the relevant line
in the table and click the DELETE button ( ).
After completing the work with records, click the APPLY button.
Page 110 of 238
To Next Page
Loading...
