D-Link N300 - Page 175

DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
In order to enable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the right. Then specify the needed parameters.
Parameter Description
Configuration
Remote subnet
The IP address of the remote subnet where the SNMP manager is
located.
Hostname
A name of the router for identification in the SNMP manager.
The contact information
for the administrator
Additional information used to contact the administrator of the
router.
System location
Additional information used to locate the router.
After specifying the needed parameters, click the APPLY button.
In order to disable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the left and click the APPLY button.
If the SNMP manager operates over SNMPv2c, create a read-only community which will be used
by the SNMP manager to get data on the device. To do this, in the Communities section, click the
ADD button and specify the community name in the line displayed. Then click the APPLY button.
To remove a community, click the Delete icon ( ) in the relevant line. Then click the APPLY
button.
If the SNMP manager operates over SNMPv3, create a read-only user which will be used by the
SNMP manager to get data on the device. To do this, in the Users section, click
the ADD button ( ).
Figure 144. The window for adding a user.
Page 175 of 238