D-Link N300 - Page 228

DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
Telnet
On the System / Telnet page, you can enable or disable access to the device settings via TELNET
from your LAN. By default, access is disabled.
Figure 180. The System / Telnet page.
To enable access via TELNET, move the Enable Telnet switch to the right. In the Port field, enter
the number of the router's port through which access will be allowed (by default, the port 23 is
specified). Then click the APPLY button.
To disable access via TELNET again, move the Enable Telnet switch to the left and click the
APPLY button.
Page 228 of 238