100D-Link DAP-3666 User Manual
Troubleshooting
What shoudl I do if I forget my password?
If you forgot your password, you must reset your access point. Unfortunately, this process will change all your settings back to the factory
defaults.
y To reset the access point, locate the reset button (hole) on the bottom of the unit. With the access point powered on, use a paperclip to hold
the button down for 10 seconds. Release the button and the access point will go through its reboot process. Wait about 30 seconds to access
the access point. Make sure the AP is connected to the DHCP server and obtain the address as set for the network. By the default, the AP’s LAN
settings are congured to DHCP. In the event that the DHCP server does not provide an IP address, type either of the following in the web
browser’s address bar to access the AP: 192.168.0.50 or dap3666.local.
How do I check my IP address?
After you install your network adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps below.
1. Click on Start > Run. In the run box type cmd and click OK.
2. At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some rewall software programs
may block a DHCP request on newly installed adapters.
If you are connecting to a wireless network at a hotspot (e.g. hotel, coee shop, airport), please contact an employee or administrator to verify
their wireless network settings.
To Next Page
Loading...
