D-Link Nuclias DNH-100

Nuclias Connect Software User Manual Nuclias Connect Conguration
Page 28
The Locate Device function can help identify unlabled switches by lighting up the LEDs on the switch. Click the Start button
to light up the switch. All LEDs will light up in green for 5 minutes. Click the Stop button to stop the light immediately. If a
device is located, a message "Locating device..." will be displayed under the Locate Device Result eld. If no devices can be
located, a message "The device is unreachable" will be displayed. If the server receives failure message sent by the switch, a
message "Locate device failed" will be displayed.
The Copy Conguration function allows you to copy Conguration Mode, VLAN Conguration, IGMP Snooping, Port
Settings, Aggregate Management, and Mirror Management settings from your device to other device(s) in the network.
(Note that the two device needs to be the same model.)
To copy the conguration, select the switch(es) in the network that will be copied. Click the Copy button to copy the
conguration from your device to the selected device(s). A pop-up window will conrm once again. Click Copy to continue or
Cancel to stop.
Monitor
Tools
Nuclias Connect
Switch Device Detail Page