D-Link ShareCenter DNS-340L - Disk Management; Hard Drive Configuration

80D-Link ShareCenter DNS-340L User Manual
Section 4 - Conguration
Disk Management
Hard Drive Conguration
To setup the Hard Drive RAID conguration of your ShareCenter, click the Management tab and then the Disk Management
icon. Select the Hard Drive Conguration menu item on the left of the window. This menu will allow you to set the RAID type
and format your hard drives.
Hard Drive
Conguration:
Your ShareCenter hard drives can be congured here
and formatted in various RAID congurations.
Current Raid Type:
If the drives are already formatted the RAID
conguration will be displayed here.
Set RAID type and
Reformat:
Click this button to launch a wizard that allows you to
select the RAID conguration and format the drives.
Auto-Rebuild
Conguration:
If you have chosen RAID 1 as the conguration option,
you can Enable or Disable the Auto-Rebuild function
here using the radio buttons.
Enable Auto-Rebuild:
Enabling Auto-Rebuild will rebuild a failed RAID 1
drive when a new drive has replaced the failed one.
Disable Auto-Rebuild:
If you do not want to automatically rebuild drives after
a failure when using the RAID 1 functionality then you
can check this option.
Note: You can still rebuild a drive using the RAID 1
functionality however you must initiate the rebuild
manually.
Manually Rebuild Now:
If Auto-Rebuild is disabled then you can use the
Manual Rebuild option by clicking this button.