dacell DN-100 - 8. Device Setting Modes; 8-1. Overview of Setting Modes and Setup

8. Setting Modes
8-1. Types of Setting mode & Set-up
For Setting mode, there are 4 different types of mode such as Function mode, Digital
calibration mode, Actual load calibration mode and SPAN constant calibration mode.
13
Measuring mode
While key is being
pressed, press
key
Function mode
END
①
Digital calibration
mode
END
②
END
③
Actual load
calibration mode
① Function mode: Access to each function setup mode. Please refer 8-2 Function
Mode.
② Digital calibration mode: It is to calibrate into the sensor’s out
p
ut value. No need to
prepare for the actual load (standard weight). Please refer 8-3 How to calibrate.
③ Actual load calibration mode: It is to calibrate by adding the actual load (Standard
weight or the load you know). Please refer 8-4 How to calibrate.
④ SPAN constant calibration mode:
It is to calibrate with the S.CAL value written
down for load calibration. Please refer 8-5 How to calibrate.
END
④
SPAN constant
calibration mode