English 133
Maintaining your appliance
4. Lower the oven door to the fully
open position. If the oven door does
not open to a full 90°, repeat steps 1
through 3.
5. Locate the oven-door hinge locks in
the corners of the oven door, and
rotate the hinge locks toward the oven
cavity to the locked position. See Step
3 (illustration A) in the "Removing
the oven door" section for the proper
locked position.
6. Close the oven door.
7. When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
8. Reconnect the LED light's Wire
Harness.
CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward to arrange
them as they were before you removed the door. Wires that are not connected or
arranged correctly can be caught in the door or damaged by heat.
NQ9300M_MOD_DOC30M977D_DE68-04463A-01_EN.indd 133 5/2/2017 4:00:08 PM
To Next Page
Loading...
Need help?
General
