3. To drain the used fluid, place the
oil container under the transmis-
sion case and remove the drain
plug to drain used uid.
If the uid does not ow out freely,
unscrew the breather plug on the
side of the hydraulic cylinder on
the left of the top link bracket to
facilitate drainage. (Refer to next
page) Reinstall the drain plugs se-
curely afterward.
(1) Drain Plug
4. Unscrew the fluid filter from the
rear right section on the tractor us-
ing a lter wrench.
td2O709s
(1) Oil Dipstick (2) Oil Filler Plug
(A) Oil Level Is Acceptable Within This Range
5. Apply a thin lm of clean oil onto
the O-ring of a new lter.
6. Tighten the lter until it touches the
mounting surface. Then, tighten
the lter for a half turn further with
a hand.
7. After installing a new lter, run the
engine for a few minutes and stop
it.
8. Check the oil level again and add
more oil to the specied level.
td2O704A
To Next Page