74
• Recording a TV program is
impossible.
• Once pressing “REC”, a videotape
is ejected automatically.
• Timer recording of Cable TV does
not work.
• In spite of pressing “CHANNEL”, a
channel can not be set.
• While duplicating, screen is not
clean and distorted.
➤ Check whether a tape attached with a recording tap is inserted.
➤ Check whether the screen is displayed in VCR Only Channel.
Press [OUTPUT] button in this remote controller to adjust in
"General Broadcast" condition.
➤ Is the rounded line (coaxial cable) connected in "ANT.IN"
terminal?
➤ Is the selected channel number shown in Display?
➤ Is a tab of cassette tape broken? (Please cover a tab hole with
cellophane adhesive tape (Scotch tape).)
➤ Please check whether the clock is right.
➤ Does the display on your video show “
”
(Ready to timer
recording)? Please make it out.
➤ Please check whether the timer recording info is right.
➤ Please check a tab on a tape whether it is broke or not. (If it was
broken, please scotch-tape it)
➤ Was a cable data output code connected correctly?
➤ Were a converter manufacturer setup and output channel right?
➤ Did you enter a password? (Please cancel it.)
➤ Did you turn off your player? (Please turn it on.)
➤ You may not memorize channels.
➤ Please check your channel setting or press a number button.
➤ Some tapes or discs distributed in the market for lending is set to
prevent copy in manufacturing. These tapes cannot be
duplicated in a good condition.
Checks
Symptom
• The remote control does not work.
• Buttons on the remote control do
not work.
■ remote control
➤ Battery may be weak or exhausted.
➤ A receiver of the remote control may be different with a sender.
➤ In case a videotape is positioned in the beginning, “VISS REW”
and “REW” do not work.
➤ In case a videotape is positioned in the end, “FF”, “VISS FF”,
“PLAY” and “REC” do not work.
➤ Please check whether another button is pressed.
DVD-Video(PAL) 02.3.15 5:45 PM ˘`74
To Next Page
Loading...
