Switch Configuration 42
Select the created instance id is
configured
Priority setting bridge example,
the default instance bridge priority
for 32768
Whether to open the STP bridge
function
The model is divided into: the
STP, RSTP, MSTP
Switches sends bpdu in packet
interval
Ports are not yet received a
message in the time, will initiate
topology changes
The state of the port switch time
Set port instance priority, defaults
to 128, you must enter multiple of
16, the range of 0-240
Select configuration state
Select configuration state
Select configuration state
Select configuration state
Select configuration state
Select configuration state
Select configuration state
Select configuration state
Select configuration state
【Instruction】
(hello_time+1)×2<=max_age<=(f_delay-1)×2 , enable the switch to set instance Step 1
priority.
Enable STP or switch mode would spend 2 times of the forward delay time. Step 2
【Configuration Example】
Open the STP, configuration has to create an instance of the priority, configuration time Step 1
parameters, set the pattern to MSTP.
To Next Page
Loading...
Need help?
General
