User's Manual
185
Voice Prompts
Select to enable audio broadcast/voice prompts in response to a local
alarm event.
More Setting
Show Message: Select the
check box to enable a
pop-up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the Device.
Video Matrix: Select the check box to enable the function. When an
alarm event occurs, the video output port outputs the settings
configured in "
Main Menu > DISPLAY > TOUR
."
Not all models support this function.
Send Email:
Enable the system to send an email notification when
an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL
.
Log: Select the check box to enable the Device to record a local
alarm log
Click OK to save the settings.
On the Wireless Detector interface, click Apply to complete the settings.
5.11.2 Configuring Temperature and Humidity Camera
You can view, search and export the temperature and humidity data of camera with such sensors and
configure the alarm event settings.
To use this function, please make sure there is at least one camera with temperature and humidity
sensor has been connected to the Device.
5.11.2.1 Enabling Detecting Function
You should enable the IoT function the first time when you enter this interface.
On the main menu, select IoT > MANAGER > Temperature/Humidity.
To Next Page
Loading...
Need help?
General
