User's Manual
167
Max Temperature In the
box, enter the max temperature value.
Alarm Out
Click
to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Latch
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Send Email
Select the
check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > EMAIL
.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Voice Prompts
Select to enable audio broadcast/voice prompts in response to a Device
alarm event.
Click Apply to complete the settings.
5.10.5 Alarm Input Settings
Connect the alarm input and output ports by referring to "4.3 Connecting to Alarm Input and Output."
You can configure the alarm settings for each channel individually or apply the settings to all channels
and then save the settings.
5.10.5.1 Configuring Local Alarms
You can connect the alarm device to the alarm input port of the Device. When the alarm is activated
on the alarm device, the alarm information will be uploaded to the Device, and then the Device
outputs the local alarms in the way that you configure in this section.
Select Main Menu > ALARM > ALARM INPUT > Local.