Local Basic Operations 239
Table 4-54
The allowable maximum clients accessing the Device at the same
time, such as WEB, Platform, and Mobile Phone.
Select a value between 1 and 128. The default value setting is 128.
The default value setting is 37777. You can enter the value
according to your actual situation.
The default value setting is 37778. You can enter the value
according to your actual situation.
The default value setting is 80. You can enter the value according
to your actual situation.
If you enter other value, for example, 70, and then you should enter
70 after the IP address when logging in the Device by browser.
The default value setting is 554. You can enter the value according
to your actual situation.
Data transmission. The value range is from 1 through 65535. The
default value is 38800.
HTTPS communication port. The default value setting is 443. You
can enter the value according to your actual situation.
Step 4 Click Apply to complete the settings.
4.12.3 PPPoE
PPPoE is another way for the Device to access the network. You can establish network
connection by configuring PPPoE settings to give the Device a dynamic IP address in the WAN.
To use this function, firstly you need to obtain the user name and password from the Internet
Service Provider.
Step 1 Select Main Menu > NETWORK > PPPoE.
The PPPoE interface is displayed. See Figure 4-210.
To Next Page
Loading...
Need help?
General