Local Basic Operations 77
Figure 4-52
Step 10 Click Finished to complete the setup.
4.2.3 Short-Cut Menu to Register Camera
If you have not registered a remote device to a channel, go to the preview interface to add.
Step 1 On the Preview interface, Move your mouse to window.
There is an icon “+” on the channel window. See Figure 4-53.
Figure 4-53
Step 2 Click “+”, device pops up interface to add network camera. Refer to "4.1.4.4
Registration" for detailed information.
4.2.4 Image
You can set network camera parameters according to different environments. It is to get the best
video effect.