Dahua Unit VTO6221E-P User Manual

Initialization 1
1 Initialization
For first time login or after the VTO being reset, you need to initialize the web interface. The
default IP address of the VTO is 192.168.1.110, and make sure the PC is in the same network
segment as the VTO.
Connect the VTO to power source, and then boot it up. Step 1
Open the internet browser on the PC, then enter the default IP address of the VTO in Step 2
the address bar, and then press Enter.
The Device Init interface is displayed. See Figure 1-1.
Device initialization Figure 1-1
Enter and confirm the password, and then click Next. Step 3
The Email setting interface is displayed.
Select the Email check box, and then enter your Email address. This Email address Step 4
can be used to reset the password, and it is recommended to finish this setting.
Click Next. The initialization succeeded. Step 5
Click OK. Step 6
The login interface is displayed. See Figure 1-2.

Dahua Unit VTO6221E-P Specifications

General

Brand	Dahua
Model	Unit VTO6221E-P
Category	Door Opening System
Language	English