Local Setting 13
Enter the domain name of the NTP server.
The time zone of the current area.
The port number of the NTP server.
The time interval that the VTO syncs time with the NTP server, and it
is 30 min at most.
Select the day and time for the auto maintenance, and the VTO will
reboot then.
Select the Enable check box, and then you can connect debugging
devices to the VTO through SSH protocol.
Click Save. Step 3
Security 4.5
On the main interface (Figure 3-1), select Local Setting > Security. Step 1
The Security interface is displayed. See Figure 4-6.
Security Figure 4-6
Configure parameters, and for the detailed description, see Table 4-6. Step 2
Table 4-6 Security parameter description
Select the check box to enable, and then you can use CGI command.
Select the check box to enable, and then the password resetting is
available.
Click Save to save. Step 3
Wiegand 4.6
This section introduces how to configure the parameters for Wiegand devices.
On the main interface (Figure 3-1), select Local Setting > Wiegand. Step 1
The Wiegand interface is displayed. See Figure 4-7.
Wiegand Figure 4-7
Configure parameters. See Table 4-7. Step 2
To Next Page
Loading...