Dahua Unit VTO6221E-P - 5.3 VTS Management

Household Setting 20
Countdown notice Figure 5-7
Swipe the card that needs to be authorized on the VTO, and then the Issue Card Step 2
dialogue box is displayed. See Figure 5-8.
Issue Card Figure 5-8
Enter the name you need, then click Save, and then click Confirm Send Card at the Step 3
countdown notice (Figure 5-7).
The issued access card is displayed. See Figure 5-9.
Issued access card Figure 5-9
You can configure the access card.
Step 4
 Click to set it to the main card, and then the icon turns into . The main
card can be used to issue access card for this room on the VTO. Click again to
resume.
 Click to set it to the lost state, and then the icon turns into . The card
under lost state cannot be used to open the door. Click again to resume.
 Click to modify the user name.
 Click to delete the card.
VTS Management 5.3
You can add VTS device to the SIP server, and the VTS can be used as the management
center. It can manage all the VTO and VTH devices in the network, make or receive video call
from them, and make basic configurations. For the detailed introduction, see the corresponding
user's manual.
Log in the web interface of the SIP server, and then select Household Setting > VTS Step 1
Management
The VTS Management interface is displayed. See Figure 5-10.