Dahua Unit VTO6221E-P - 6.2 FTP

Network Setting 28
FTP Figure 6-2
Configure parameters. See Table 6-1. Step 2
Table 6-1 FTP parameter description
Parameter
Description
Enable
Select the check box to enable FTP function.
Name
Enter the name of the FTP server as needed.
IP Addr.
The IP address of the FTP server.
Port
It is 21 by default.
Username
The username and password of the FTP server.
Password
Click Save. Step 3
UPnP 6.3
Universal Plug and Play, a protocol that establishes mapping relation of ports in LAN and WAN.
This function enables you to visit local area device through wide area network.
 This function is valid only when VTO works as SIP server.
 This function is needed only when the VTO is connected to a router with UPnP function.
Select Network Setting > UPnP. Step 1
The UPnP interface is displayed. See Figure 6-3.