Local Setting 10
4.3.1 Local
On the main interface (Figure 3-1), select Local Setting > Access Control > Local. Step 1
The Local interface is displayed. See Figure 4-3.
Local Figure 4-3
Configure parameters, and for the detailed description, see Table 4-3. Step 2
Table 4-3 Local access control parameter description
Unlock Responding
Interval
The time interval to unlock again after the previous unlock, and the
unit is second.
The time amount for which the lock stays open after unlock, and
the unit is second.
If you have installed door sensor, then you can configure the time
period, and If the unlock time exceeds the Door Sensor Check
Time, the door sensor alarm is triggered, and the alarm will be sent
to the management center.
Select the Enable check box, and the door will not be locked
until the door sensor contacts each other.
If you do not select the Enable check box, the door will be
locked after the Unlock Period finishes.
This password can be used to issue new card.
This password is only for admin people or engineer.
It is 888888 by default.
It can be used to go to the engineering interface, and it is 888888
by default.
Project password is only for admin people or engineers.
You can connect a third-party phone such as SIP phone to your
VTO, and use the command to open the door remotely.
Select NC or NO according to the lock you use.
Select the Enable check box, then configure the public unlock
password, and then all the residents in this unit can open the door
with this password.
Public Unlock
Password Confirm
To Next Page
Loading...